Continuity Between Positive And Negative Battery Cables. So when I hook up the 12v. I have continuity between the pos and neg battery terminals when the key is in Run or Start but not Acc I also have continuity when I step on the brakes or turn on the headlights.
Discussion Starter 1 Sep 8 2018. It was a positive wire. The switch is turned off and i have no alarm.
Now connect the red and black probes to the positive and the negative terminals respectively.
Clearly it should be a lot greater than 4 ohms. There should be a wire that comes off the negative cable that bolts to the fender. So yes it is possible to have continuity to the block through positive wire without any load. An inductor is a coil and to test it you must remove it from the circuit.
